Sony RDR-HX900 Operating Instructions Manual page 27

"16:9": For wide-screen TVs or standard TVs
with a wide screen mode.
For details, see "TV Type" on page 87.
18
Press ENTER.
The Setup Display for selecting the type of
jack used to connect to your amplifier
(receiver) appears.
EASY SETUP
Is this recorder connected to an amplifier (receiver)?
Select the type of jack you are using.
LINE OUT(R-AUDIO-L)
Yes :
DIGITAL OUT
Yes :
No
19
Select the type of jack (if any) you are
using to connect to an amplifier (receiver),
and press ENTER.
If you did not connect an AV amplifier
(receiver), select "No," then go to step 23.
If you connected an AV amplifier (receiver)
using just an audio cord, select "Yes: LINE
OUT (R-AUDIO-L)," then go to step 23.
If you connected an AV amplifier (receiver)
using either a digital optical or coaxial cord,
select "Yes: DIGITAL OUT."
20
Select the type of Dolby Digital signal you
wish to send to your amplifier (receiver).
EASY SETUP
Dolby Digital
D-PCM
Dolby Digital
If your AV amplifier (receiver) has a Dolby
Digital decoder, select "Dolby Digital."
Otherwise, select "D-PCM."
Audio Connection 7/7
Audio Connection 7/7
21
Press ENTER.
The Setup Display for the DTS signal appears.
EASY SETUP
DTS
On
Off
22
Select whether or not you wish to send a
DTS signal to your amplifier (receiver),
and press ENTER.
If your AV amplifier (receiver) has a DTS
decoder, select "On." Otherwise, select "Off."
23
Press ENTER when "Finish" appears.
Easy Setup is finished. All connections and
setup operations are complete.
If you use the cable box/satellite receiver
control, check that the control works correctly
(see below).
EASY SETUP
Easy Setup is finished.
Finish
You must leave the recorder turned off for
at least 24 hours to receive the TV Guide
On Screen data. If your recorder is
connected to a cable box, be sure to leave
the cable box turned on.
To return to the previous step
Press O RETURN.
z Hint
If you want to run Easy Setup again, select "Easy Setup"
in the Setup Display (page 95).
Notes
• To record TV programs using the timer, you must set
the clock accurately.
• If you use an S-video cord to connect your cable box or
satellite receiver, set "Line1 Input" or "Line3 Input" in
Video Setup to "S Video" (page 89).
Audio Connection 7/7
,continued
27