Typical Functions And Conditions - Icom IC-F620 Programming Software Manual

Function How to Use
Power On When the radio is first activated, it will briefly display the text entered in the
Opening Text field of the Field Data programming screen. It will then show the
firmware version.
System Up/Down The current System can be displayed by pressing either of the System Up/Down
Keys and keys. Another press of either key will change the system (if there is more than one
Group/MIN system in the radio). The current group can be displayed by pressing either of the
Up/Down Keys Group Up/Down keys. Another press of either key will change the group (if there is
more than one group in the system).
Group Dispatch After the radio has registered, it is normally ready to perform "Group Dispatch". To
call a base unit or other field units, simply press the PTT key. Wait until you get the
PTT "handshake" tone and then start speaking. It is a common mistake for first time
users to attempt to "over talk" this tone, but after a couple of minutes of practice the
user should have no further difficulties. In Group Dispatch mode, all users registered
to a particular group will hear any unit transmitting on that group.
Scan For a detailed description of how to use the scan function, refer to the P
description in the previous table. Remember, many scan functions can be enabled or
prohibited or set to a default on a system-by-system basis. Refer to the fields in the
Scan group in the LTR programming screen.
CS-F620TR Programming Software Manual
T F
YPICAL UNCTIONS AND
C
ONDITIONS
LTR Trunking
(rev 1.0) -
key
0
77