Kodak IMAGELINK 500 User Reference page 35

Error Code Number and Message
E223_Jam_-_Vert
Trans/Exit_Area
A-61409 April 1994
Required Action(s)
Operator Action
Open the access door and transport plate
corresponding to the jam area and remove all damaged
documents (optional). Close all transport plates and
access doors and the warming up process will
commence. When the warming up process is complete
(or directly after the error message is displayed), press
the Jog key to remove all documents still in the
transport system. The Image Address is automatically
set to the correct address, but verify the Image Address
and Image Level, and then re-scan the documents
whose images have not yet been transferred to the host;
when the Run key is pressed, if documents are detected
under any of the document sensors the error message
"E234 Press JOG To Remove Docs" will be displayed.
If the operator does not have access to the Image
Header to determine which documents have been
scanned, then contact the system administrator to
determine the last image that was transferred to the
host. If the error message persists, contact the system
administrator.
System Administrator Action
Verify correct operation. If the error message persists,
call service.
OM-19