Threading Welding Wire - Hobart Multi-Handler 200 Owner's Manual

5-15. Threading Welding Wire

Tools Needed:
Open pressure assembly.
Close and tighten pressure
assembly, and let go of wire.
Press gun trigger until wire
comes out of gun. Reinstall
contact tip and nozzle
OM-285922 Page 28
1
4
2
3
5
6
.
Hold wire tightly to keep it
from unraveling.
Pull and hold wire; cut off end.
.
Use pressure indicator scale to set a desired
Tighten
drive roll pressure. Begin with a setting of 2.
If necessary, make additional adjustments
after trying this initial setting.
Pressure
1
Indicator
2
3
Scale
4
Remove gun nozzle and contact tip.
WOOD
Feed wire to check drive roll pressure.
Tighten knob enough to prevent slipping.
6 in.
(150 mm)
Push wire through guides into gun;
continue to hold wire.
Tighten
1
2
3
4
Ref. 287758A / 275167A / 801 083 / Ref. 800 924-D
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Input Liner
7 Gun Conduit Cable
Lay gun cable out straight.
7
Turn On.
Cut off wire. Close
and latch door.