Replacing The Agp Card - Dell Dimension 4300 Solution Manual

2H930bk1.book Page 76 Tuesday, November 20, 2001 5:02 PM
FILE LOCATION: C:\Projects\Green_Lantern_solutions\2H930c31.fm FILE LOCATION: FILE LOCATION: FILE LOCATION:
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1 D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 1 1 / 2 0 / 0 1
76 Ad d i n g Par ts
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
Right-click the My Computer icon and then click Properties.
11
Click the General tab.
12
To verify that the memory is installed correctly, check the amount of
13
memory (RAM) listed.

Replacing the AGP Card

CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in "When Working Inside
Your Computer" on page 12.
Shut down the computer (see page 20).
1
Turn off any attached devices and disconnect them from their
2
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
Disconnect the computer power cable from the wall outlet, and then
3
press the power button to ground the system board.
Open the computer cover (see page 65).
4
Press the card clip lever on the side of the AGP card to release the card
5
from the slot connector, and remove the card.
AGP card
card clip
lever
AGP card clip
slot connector
back of computer