Removing The Agp Card Brace; Replacing The Agp Card Brace - Dell OptiPlex GX400 Service Manual

Back to Contents Page
AGP Card Brace
Dell™ OptiPlex™ GX400 Service Manual
Removing the AGP Card Brace
Replacing the AGP Card Brace

Removing the AGP Card Brace

To access some components on the board, you may need to remove the AGP card brace.
NOTE: Your computer has either an AGP card brace or an
CAUTION: Before you perform this procedure, see
1. Turn off the computer and devices, disconnect them from their electrical outlets, wait at least 5 seconds, and then
2. Remove the screw that secures the AGP card brace to the chassis.
Removing the AGP Card Brace
3. Rotate the brace up until the tab disengages from the card guide at the front of the chassis. Then lift the brace away from the chassis.

Replacing the AGP Card Brace

To replace the AGP card brace, perform the
Back to Contents Page
AGP card clip.
"Precautionary
removal procedure in reverse.
Measures."
remove the computer cover.