Using Dell Pc Restore By Symantec - Dell Dimension 2400 Series Owner's Manual

Undoing the Last System Restore
NOTICE:
Before you undo the last system restore, save and close all open files and exit any open
programs. Do not alter, open, or delete any files or programs until the system restoration is complete.
1
Click the Start button, point to All Programs
System Restore.
2
Click Undo my last restoration and click Next.

Using Dell PC Restore by Symantec

Use Dell PC Restore by Symantec only as the last method to restore your operating system. PC
Restore restores your hard drive to the operating state it was in when you purchased the computer.
Any programs or files added since you received your computer
permanently deleted from the hard drive. Data files include documents, spreadsheets, e-mail
messages, digital photos, music files, and so on. If possible, back up all data before using PC
Restore.
NOTICE:
Using PC Restore permanently deletes all data on the hard drive and removes any applications or
drivers installed after you received your computer. If possible, back up the data before using PC Restore.
To use PC Restore:
1
Turn on the computer.
During the boot process, a blue bar with www.dell.com appears at the top of the screen.
2
Immediately upon seeing the blue bar, press <Ctrl><F11>.
If you do not press <Ctrl><F11> in time, let the computer finish restarting, and then
restart the computer again.
NOTICE:
If you do not want to proceed with PC Restore, click Reboot in the following step.
3
On the next screen that appears, click Restore.
4
On the next screen, click Confirm.
The restore process takes approximately 6–10 minutes to complete.
5
When prompted, click Finish to reboot the computer.
NOTE:
Do not manually shut down the computer. Click Finish and let the computer completely reboot.
6
When prompted, click Yes.
The computer restarts. Because the computer is restored to its original operating state, the
screens that appear, such as the End User License Agreement, are the same ones that
appeared the first time the computer was turned on.
7
Click Next.
The System Restore screen appears and the computer restarts.
8
After the computer restarts, click OK.
Accessories System Tools, and then click
including data files—are
—
Advanced Troubleshooting
43