Ieee 1394 Device Problems - Dell Dimension 2400 Series Owner's Manual

ON SYSTEM DISK ERROR — Remove the floppy disk from the drive and restart your computer.
N -
N OT ENOUGH MEMORY OR RESOURCES
the program that you want to use. In some cases, you might have to restart your computer to restore
computer resources. If so, run the program that you want to use first.
PERATING SYSTEM NOT FOUND
O
x:\ IS NOT ACCESSIBLE . T HE DEVICE IS NOT READY
disk into the drive and try again.

IEEE 1394 Device Problems

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
E NSURE THAT THE IEEE 1394
E NSURE THAT THE IEEE 1394
Windows XP
Click the Start button and click Control Panel.
1
Click Printers and Other Hardware.
2
If your IEEE 1394 device is listed, Windows recognizes the device.
F YOU HAVE PROBLEMS WITH A
I
F YOU HAVE PROBLEMS WITH AN
I
Contact Dell (see page 78) or the IEEE 1394 device manufacturer.
. C LOSE SOME PROGRAMS AND TRY AGAIN
— Contact Dell (see page 78).
— The floppy drive cannot read the disk. Insert a floppy
DEVICE IS PROPERLY INSERTED INTO THE CONNECTOR
DEVICE IS RECOGNIZED BY W INDOWS
ELL PROVIDED DEVICE
D - IEEE 1394
DEVICE NOT PROVIDED BY
IEEE 1394
— Close all windows and open
—
—
ELL
D —
23
Solving Problems