Adding A Second Cd Or Dvd Drive - Dell Dimension 2400 Series Owner's Manual

22
Press <Enter>.
23
Press <Esc>.
24
Press <Enter> to Save changes and Exit.
The computer restarts.
25
See the documentation that came with the drive for instructions on installing any software
required for drive operation.

Adding a Second CD or DVD Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1
Shut down the computer through the Start menu (see page 18).
NOTE:
Drives sold by Dell come with their own operating software and documentation. After you install a
drive, see the documentation that came with the drive for instructions on installing and using the drive
software.
2
Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer, turn
them off now.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it
from the network wall jack.
3
Disconnect any telephone or telecommunication lines from the computer.
4
Disconnect your computer and all attached devices from their electrical outlets, and then
press the power button to ground the system board.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
5
Remove the computer cover (see page 49).
6
Release and remove the front panel:
Push the release lever to release the top tab.
a
Reach inside the computer and push the bottom tab towards you to release it (the middle
b
tab releases automatically).
Rotate the front panel to separate it from the side hinges.
c
Removing and Installing Parts
59