Table of Contents
Advertisement
6.2
Opening the burner
6.2.1
To open the burner
Switch off the electrical power.
WARNING
To open the burner proceed sa follows:
remove the screws 2)(Fig. 35) from the slide bars 3);
install the extention bars 4);
remove screw 1) and pull the burner back on slide bars 3) by
about 4" (Fig. 36);
disconnect the electrode wires and then pull the burner com-
pletely back;
unscrew the pin 8) from the connection 9)(Fig. 37);
push ahed the connection to the end stop on the plug
10)(Fig. 37), therefore extract the inner part of the combustion
head 12)(Fig. 36).
3
2
13
1
D10441
4"
14
Maintenance
6.2.2
To close the burner
To close the burner proceed as follows:
push the burner 13)(Fig. 36) at approximately 4" from the elec-
trical board 14);
insert the ignition electrode cables and then slide the burner
up to the sleeve so that it is positioned as shown in Fig. 35.
Disinstall and arrange in the correct site the extention bars 4);
refit screws 2) on slide bars 3);
secure the burner to the sleeve by tightening screw 1).
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
WARNING
12
D10462
Fig. 36
27
9
10
D10451
8
4
Fig. 35
Fig. 37
20026767
Advertisement
Table of Contents
