Assembly
IMPORTANT! Always remove the power plug from the power
supply before fitting or removing accessories! LIVE PARTS
within the hose, rod and powerhead.
1. Flexible Hose
Fitting:
Insert the flexible hose into the air inlet of the vacuum.
Press until it clicks into position.
Removing:
Press the two buttons and gentle pull to release the flexible hose.
2. Handle
Note: Ensure that the powerhead switch located on the
handle is in the "Off" position before fitting the handle to
the rod. When not using the powerhead, ensure that the
Powerhead On/Off Button is in the "Off" position.
a.
Gently insert the handle into the telescopic tube and push
until it clicks into place.
b.
Place the powerhead onto the floor and gently insert the
telescopic tube into the powerhead. Push until it clicks into
place.
7.