Locating Internal Components; Removing And Installing Memory; Memory Module Specifications - HP EliteOne 1000 G2 Hardware Reference Manual

Locating internal components

Components
(1) Hard drive
(2) M.2 SSD (under the fan)

Removing and installing memory

The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module.

Memory module specifications

For proper system operation, the memory modules must meet the following qualifications:
Component
Memory modules
Compliance
Pins
Support
Slots
Maximum Memory
Supported
Note
HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
(3) RTC battery
(4) Memory modules
Specification
1.2 volt DDR4-SDRAM memory modules
Unbuffered non-ECC DDR4-2400 MHZ–compliant
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support CAS latency DDR4 2400 MHz (15–15–15 timing)
2
16 GB per memory slot, 32 GB total
4 Gbit and 8 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
Locating internal components 21