Locating Internal Components; Removing And Installing Memory; Sodimms; Ddr3-Sdram Sodimms - HP ProOne 400 G1 All-in-One Hardware Reference Manual

Locating internal components

The following sections contain procedures for removing and replacing these internal components:
●
Optical disc drive
●
Hard disc drive, solid state drive, or self-encrypting drive
●
Battery
●
Memory
Figure 2-12
Component
1 Optical disc drive
2 Hard disc drive

Removing and installing memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-
SDRAM) small outline dual inline memory modules (SODIMMs).

SODIMMs

The memory sockets on the system board can be populated with up to two industry-standard
SODIMMs. These memory sockets are populated with at least one preinstalled SODIMM. To achieve
the maximum memory support, you can populate the system board with up to 16 GB of memory.

DDR3-SDRAM SODIMMs

For proper system operation, the SODIMMs must be:
●
industry-standard 204-pin
●
unbuffered non-ECC PC3-10600 DDR3-1600 MHz-compliant
●
1.5 volt DDR3-SDRAM SODIMMs
The DDR3-SDRAM SODIMMs must also:
●
support CAS latency 11 DDR3 1600 MHz (11-11-11 timing)
●
contain the mandatory Joint Electronic Device Engineering Council (JEDEC) specification
Locating internal components
Component
3 Battery
4 Memory
Locating internal components 17