HP EliteOne 1000 G2 Hardware Reference Manual page 13

8. Loosen the two captive screws at the base of the monitor head's neck (1). While holding onto the bottom
of the monitor head from the front with one hand, slide the monitor head back with your other hand to
clear it from the small metal retention tab, and then lift the monitor off the base (2).
IMPORTANT: The monitor head is heavy. Make sure you are holding the monitor head firmly when
removing it to prevent the monitor head from falling over and being damaged.
9. To replace the monitor head, hold the bottom of the monitor head from the front with one hand and
place the base of the monitor head's neck onto the bracket on the base unit and slide the monitor
forward (1) with the other hand. Then tighten the two captive screws that secure the monitor head's
neck to the base unit (2).
IMPORTANT: The monitor head is heavy. Make sure you are holding the monitor head firmly when
replacing it to prevent the monitor head from falling over and being damaged.
Installing the monitor head 7