Installing An Sfp - Avaya 4900 Series Manual

SFP+
Model
10GBASE-ZR/ZW
SFP+
10GBASE-ER
CWDM DDI SFP+
10GBASE-ZR
CWDM DDI SFP+
10GBASE-BX10
SFP+

Installing an SFP+

Install an SFP+ transceiver to provide a 10-gigabit Ethernet interface between the device and other
network devices.
Before you begin
Important:
Do not install an SFP+ transceiver in an SFP slot. The two transceivers look the same but
function differently. Ensure the slot is an SFP+ slot.
• Verify that the SFP+ transceiver is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Danger:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look into
an optical fiber or connector port. Always assume that fiber optic cables connect to a light
source.
Electrostatic alert:
ESD can damage electronic circuits. Do not touch electronic hardware unless you wear a
grounding wrist strap or other static-dissipating device.
Warning:
Risk of equipment damage
Only trained personnel can install this product.
About this task
Installing an SFP+ transceiver takes approximately 3 minutes.
Procedure
1. Remove the SFP+ transceiver from its protective packaging.
April 2016 Installing Transceivers and Optical Components on Avaya ERS 4900 and 5900
Description Part number
70 km, 1550 nm AA1403016-E6
SMF
40 km, 1471 to AA1403153-E6 to
1611 nm AA1403160-E6
70 km, 1471 to AA1403161-E6 to
1611 nm AA1403168-E6
10 km AA1403169-E6 and
AA1403170-E6
Comments on this document? infodev@avaya.com
Minimum software version
ERS 5900
7.0
7.1
7.1
7.1
Series
ERS 4900
7.1
7.1
7.1
7.1
42