Installing Ethernet Routing Switch 4900 Series
Installing SFP transceivers
About this task
This procedure describes the steps used to install transceivers.
Procedure
1. Remove the transceiver from the protective packaging.
2. Verify that the transceiver is the correct model for the network configuration.
3. Grasp the transceiver between the thumb and forefinger.
4. Insert the transceiver into the proper module on the switch. Apply a light pressure to the
transceiver until it clicks and locks into position in the module.
5. Remove the dust cover from the transceiver optical bores.
Example
The following graphic shows an SFP transceiver.
February 2016
Installing Avaya Ethernet Routing Switch 4900 Series
Comments on this document? infodev@avaya.com
36