Table of Contents
Advertisement
auto-immobilisation sequence
1.
Turn ignition off or disarm alarm
2.
After 30 seconds the systems Immobilisation circuits activate
and engage the starter and ignition interrupt
3.
LED flashes at ½ normal speed
Disarming auto-immobilisation
To disarm auto-immobilisation when active, follow any of the
sequences listed below.
Turn ignition on and press the arm/disarm button.
Arm the alarm and then disarm the alarm.
Turn the ignition on and enter the system valet/PIN code.
one-time valet feature
This feature allows the system to be put in valet mode only until the
next time the ignition is turned on. (This feature is a Thatcham and EC
requirement and, therefore is not programmable.)
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
31
Advertisement
Table of Contents
