Table of Contents
Advertisement
ters that have been lost, stolen, or incorrectly programmed
into the system.
After entering this feature press any button on the transmit-
ter; the siren will chirp to indicate that all transmitters have
been erased from memory.
pin programming
A PIN code can have one to four digits; each digit can be from 0-9.
n n o o t t e e : : A PIN code cannot begin with a zero.
Programming Procedure
1.
Enter the feature location in the installer programming grid.
2.
Immediately press and release
switch.
3.
Select each digit by pressing
to enter the number into the system. To enter a zero,
press
only.
To program a PIN code of 1032:
a.
Press and release
hear one chirp.
b.
Press and release
after programming a zero.
c.
Press and release
once. You will hear three chirps.
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
of the PlainView 2 Valet
1-9 times, and then press
once and
once. You will
once. You will not hear a chirp
three times, and then press
29
Advertisement
Table of Contents
