Genie GS-1330m Operator's Manual page 49

First Edition • Second Printing
Operation from Ground with
Controller
Maintain safe distances between the operator,
machine and fixed objects.
Be aware of the direction the machine will travel
when using the controller.
Battery Level Indicator
Use the LED diagnostic readout to determine the
battery level.
Note: When a blinking LO code appears on the
platform controls LED display, the machine must
be taken out of service and charged, otherwise all
machine functions will be disabled.
Part No. 1290846GT
How to Use the Safety Arm
1
2
3
How to Fold Down the Guardrails
The platform railing system consists of one fold
down rail section for the extension deck and one
section for the main deck. All sections are held in
place by four wire lock pins.
1
2
Full Charge
3
Half Charge
4
Low Charge
5
LO Flashing
6
™
GS -1330m
Operating Instructions
Raise the platform approximately 8 ft / 2.4 m
from the ground.
Rotate the safety arm away from the machine
and let it hang down.
Lower the platform until the safety arm rests
securely on the link. Keep clear of the safety
arm when lowering the platform.
Fully lower the platform and retract the
platform extension.
Remove the platform controls.
Fall hazard. Use caution and maintain a firm
footing on the platform floor at all times while
folding the guard rails.
From inside the platform, remove the two
extension deck lock pins.
Keep hands free of pinch points.
From the middle of the extension deck railing,
fold down the extension deck rail assembly
toward the rear of the unit.
At the rear of the main deck, remove the two
main deck lock pins.
Keep hands free of pinch points.
From the middle of the unit, fold down the main
deck railing assembly toward the front of the
unit.
Operator's Manual
47