Genie GS-1330m Operator's Manual page 32

Operator's Manual
Inspections
At the Ground Controls
1 Select a test area that is firm, level and free of
hazards.
2 Be sure the batteries are connected.
3 Pull out the platform and ground red
Emergency Stop button to the on position.
4 Turn the key switch to ground control.
5 Observe the diagnostic LED readout on the
platform controls.
Result: The LED should look like the picture
below.
6 Observe the diagnostic LCD readout on the
ground controls.
Result: The LCD should display the model and
hour meter.
Test Emergency Stop
7 Push in the ground red Emergency Stop
button to the off position.
Result: No functions should operate.
8 Pull out the red Emergency Stop button to the
on position.
30
Test the Up/Down Functions
This machine uses both flashing lights and audible
alarms. Descent alarm: Lights flash and alarm
sounds at 60 flashes/beeps per minute. Descent
delay alarm: Lights flash and alarm sounds at
180 flashes/beeps per minute. Pothole guards not
deployed: Lights flash and alarm sounds at
180 flashes/beeps per minute. Machine not level:
Lights flash and alarm soundsat 180 flashes/beeps
per minute. Horn: continuous flash and constant
tone. An optional automotive-style horn is also
available.
9 Do not press the lift function enable button.
10 Press the platform up or platform down button.
Result: The lift function should not operate.
11 Do not press the platform up or platform down
buttons.
12 Press the lift function enable button.
Result: The lift function should not operate.
13 Press and hold the lift function enable button,
and press the platform up button.
Result: The outdoor area of operation should
be selected and the platform should raise.
14 Press and hold the lift function enable button,
and press the platform down button.
Result: The platform should lower. The
descent alarm should sound while the platform
is lowering.
When lowering the platform, the platform should
stop when it is approximately 1.5 m from the
ground. The descent delay lights will flash and the
alarm will sound. Be sure the area below the
platform is clear of personnel and obstructions
before continuing. To continue lowering, release
the control handle, and then move the control
handle again.
™
GS -1330m
First Edition • Second Printing
Part No. 1290846GT