Genie GS-1330m Operator's Manual page 36

Operator's Manual
Inspections
57 Fully lower the platform.
58 Drive the machine.
Result: The machine should drive.
59 Return to level ground and raise the platform
in excess of approximately 7 ft / 2.13 m.
60 Drive the machine onto a slope where the
pitch angle is greater than 2.5° front to back.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the tilt
alarm will sound at 180 beeps per minute. The
platform controls LED readout should display
LL and the ground controls LCD should display
LL: Machine Tilted.
Fully lower the platform and return to level
ground.
Test Elevated Drive Speed
61 Raise the platform approximately 4 ft / 1.2 m
from the ground.
62 Press the drive function button.
63 Press and hold the function enable switch on
the control handle.Slowly move the control
handle to full drive position.
Result: The maximum achievable drive speed
with the platform raised should not exceed
0.72 ft / 22 cm per second.
If the drive speed with the platform raised exceeds
0.72 ft / 22 cm per second, immediately tag and
remove the machine from service.
34
Test the Pothole Guards
Note: The pothole guards should automatically
deploy when the platform is raised. The pothole
guards activate limit switches that allow the
machine to continue to function. If the pothole
guards do not deploy, an alarm sounds and the
machine will not drive or steer.
64 Raise the platform.
Result: When the platform is raised 4 ft / 1.2 m
from the ground, the pothole guards should
deploy.
65 Press on the pothole guards on one side, and
then the other.
Result: The pothole guards should not move.
66 Lower the platform.
Result: The pothole guards should return to
the stowed position.
67 Place a 2x4 or similar piece of wood under a
pothole guard.
68 Raise the platform.
Result: Before the platform is raised 7 ft /
2.1 m from the ground, an alarm should sound.
The platform controls LED readout should
display PHS and the ground controls LCD
should display PHS: Pothole Guard Stuck.
™
GS -1330m
First Edition • Second Printing
Part No. 1290846GT