Table of Contents
Advertisement
Chapter 4
Communication Ports
Section 4.2
PoE Ports
The RUGGEDCOM RSG2100PF comes standard with two 10/100Base-TX Power over Ethernet (POE) ports powered
by an external power supply. Each port complies with the IEEE 802.3af standard and features auto-sensing and
automatic power off when cables are removed.
PoE ports are located in slots 9 and 10.
The total allowable power budget for all ports is 60 W. If the external power supply is less than 75 W, to prevent
exceeding the power budget, port priorities can be set via the RUGGEDCOM ROS-F operating system to disable
low priority ports when demand is too high. Ports can also be enabled/disabled and placed on a power schedule
to conserve power. For more information, refer to the RUGGEDCOM ROS-F User Guide for the RUGGEDCOM
RSG2100PF.
For information about connecting the external power supply, refer to
Power".
LEDs
Each port features a dedicated LED that indicates the state of the port.
State
Yellow (Solid)
Yellow (Blinking)
Off
Pin-Out
The pin-out for the PoE ports is as follows:
8
Figure 16: RJ45 Ethernet Port PoE Pin Configuration
Specifications
For specifications on the available PoE ports, refer to
24
Description
Link established
Transmitting/receiving
No link detected
1
Section 5.2, "PoE Power Supply
Section 2.5.2, "Connecting External PoE
Pin
1
2
3
TX + and Power +
4
Reserved (Do Not Connect)
5
Reserved (Do Not Connect)
6
7
Reserved (Do Not Connect)
8
Reserved (Do Not Connect)
Specifications".
RUGGEDCOM RSG2100PF
Installation Guide
Description
RX + and Power -
RX - and Power -
TX - and Power +
PoE Ports
Advertisement
Table of Contents
