Surround & Trim Kit Installation - Quadra-Fire 27I-ACC Installation Manual

E. Surround & Trim Kit Installation
1. Lay surround face down on a protected surface to
prevent scratching.
2. Using a Phillips head screw driver attach the side
surrounds to the top surround using 2 #8 sheet metal
screws provided with the kit (Figure 19.1).
3. Lay the trim face down and place the corner brackets
into position.
4. Using a standard flat screw driver tighten the corner
brackets (Figure 19.2).
5. Slide the trim over the surround set.
6. Install the surround set and trim set to the outer can.
Place the hook in the surround sides over the surround
attachment screws, 2 on each side (Figure 19.3).
7. Place top on top of appliance.
Secure 2 Side Surrounds to
Figure 19.1
Corner Brackets
Figure 19.2
Figure 19.3
November 22, 2019
Top Surround
8. Align the 2 screws in the top surround piece to the 2
alignment holes on the appliance top (Figure 19.4).
9. Align the surround slots to the lower pins on the
appliance, one on each side (Figure 19.5).
F. Top Installation Instructions
NOTE: The top is packaged separately and shipped
with the appliance. Install after the appliance is in
place and the installation of the surround and trim
are complete.
1. Push the top into place by aligning the pins into the
slots (Figure 19.6).
2. Press down into position.
Figure 19.6
7046-192I
2700 Insert ACC
Alignment Screw
in Surround Top
Alignment Hole
in Appliance Top
Figure 19.4
Alignment
Appliance
Start-Up Air
Control
Figure 19.5
Surround Top
Top
Pin on
Surround
Alignment
Slot
19