Maintenance
Cleaning the water inlet filter
A filter is incorporated in the screw
connection of the valve on the water
inlet hose. The filter must be cleaned
when dirty, otherwise insufficient water
flows into the wash cabinet.
The plastic housing of the water
connection contains an electrical
component.
The housing must not be dipped in
water.
Recommendation
If the mains water contains a large
number of insoluble substances, we
recommend fitting a large-area filter in
the connection between the tap and the
water inlet hose threaded union. This
filter is available from Miele.
Cleaning the filter
Disconnect the dishwasher from the
mains. (Switch the dishwasher off,
unplug it, or disconnect or disable the
fuse).
Turn off the tap.
Unscrew the inlet hose.
62
Carefully remove the seal from the
threaded union.
Withdraw the filter using pointed
pliers and rinse clean under running
water.
Take care when withdrawing the filter
not to pull out or dislodge the flow
regulator located underneath the
filter.
Refit the filter and seal. Make sure it
is fitted correctly.
Reconnect the inlet valve to the tap.
Ensure that the union goes on
straight and is not cross-threaded.
Turn on the tap.
If there is a leak, the inlet hose might
not be on securely, or it may have
been screwed on at an angle.
Unscrew and reconnect the inlet hose
correctly before tightening it.