Add Salt Reminder; Rinse Aid - Miele PG 8083 SCVi Operating Instructions Manual

Add salt reminder

 When 
Add salt
display wait until the end of the
programme and then refill the salt
reservoir.
 Press the middle button to confirm.
The Add salt reminder will go out.
After the salt reservoir has been filled,
the refill reminder may still appear in the
display if the salt concentration has not
yet reached the correct level. If this is
the case, press the middle button
again.
The Add salt reminder is deactivated if
the dishwasher is set to a water
hardness of less than 0.7 mmol/l (0 - 4
°d - German scale).

After refilling the salt reservoir,
run the "Pre-wash" or the "Short"
programme immediately without any
crockery in the dishwasher to
remove any traces of salt from the
cabinet.
appears in the
Commissioning

Rinse aid

Rinse aid is necessary to ensure water
does not cling to and leave marks on
crockery during the drying phase, and
helps crockery dry faster after it has
been washed.
Rinse aid is poured into the storage
reservoir and the amount set is
dispensed automatically.

Only fill the reservoir with rinse
aid. Do not fill it with washing-up
liquid or cleaning agent.
This would seriously damage the
rinse aid reservoir.
Suitable products are available from
Miele Professional.
Alternatively household vinegar with a
max. 5 % acid content or liquid citric
acid with a max. 10 % acid content can
be used. However, the resulting rinsing
and drying quality will not be as good
as when rinse aid is used.

Do not use vinegar with a higher
acid level (e.g. vinegar concentrate
25%)
This would damage the dishwasher.
23