Baofeng UV-5RV2+ Operating Manual page 58

Menu Item Shortcut
SFT-D 25
Availability: VFO/Frequency Mode, Stored in Channel
Settings/Notes
OFF[0] | + [1] | - [2] Default: OFF
OFF: TX = RX (simplex)
+: TX will be shifted higher in frequency than RX
-: TX will be shifted lower in frequency than RX
Note: When SFT-D is set to +, a '+' is indicated in the status display (VFO/Frequency mode only)
Note: When SFT-D is set to -, a '-' is indicated in the status display (VFO/Frequency mode only)
Note: Used with menu 26 to access repeaters in VFO/Frequency mode (+ and - only)
Note: SFT-D is not required when storing repeater frequencies into channels
Menu Item Shortcut
OFFSET 26
Availability: VFO/Frequency Mode, Stored in Channel
Settings/Notes
00.000 - 69.990 in 10 kHz steps
Note: Used with menu 25 to access repeaters in VFO/Frequency mode
Note: Typical ham offsets are: VHF = 00.600
Note: OFFSET is not required when storing repeater frequencies into channels
http://www.baofengradio.us
Description
Frequency ShiFT – Direction: Enables access of repeaters in VFO/Frequency Mode.
Description
Frequency Shift/OFFSET (MHz): Specifies the difference between the TX and RX frequencies.
Default: 00.600
UHF = 05.000
http://baofengradio.us
58