Baofeng UV-5RV2+ Operating Manual page 36

Channel Information Window: Column Definitions
Channel -> Channel number.
Band -> Displays what Frequency Band is active.
RX Frequency -> Receive Frequency.
TX Frequency -> Transmit Frequency. Defaults to the Receive Frequency.
CTCSS/DCS Dec -> Receiver CTCSS or DCS. Defaults to OFF.
CTCSS/DCS Enc -> Transmitter CTCSS or DCS. Defaults to OFF.
TX Power -> Transmit power. Defaults to HIGH.
W/N -> Wideband or Narrowband operation. Defaults to W for Wideband.
PTT-ID -> Enables and sets position of PTT-ID. Defaults to OFF.
BusyLock -> Busy Channel Lock-out. Defaults to OFF.
Scan_Add -> Add to scanner list. When enabled the channel is included in scanning mode. Defaults to ON.
SigCode -> Signal Code, group ID for the channel. Defaults to 1.
CH-Name -> Channel name.
To add a new channel, go to the row for the channel number you want to edit and follow these steps:
Procedure: Adding a Channel
1. Click in the RX Frequency field and enter the receiving frequency.
2. Click on the TX Frequency field and the rest of the row should fill automatically with default values (except for CH –
Name, which will remain blank)
a. If adding a duplex channel, the transmit frequency can be directly entered here.
3. Add or edit any of the information for the channel as needed.
a. An optional 6-character channel name can be entered in the CH-Name field.
To finalize any programming, go to Program -> Write to Radio and then click Write. If successful, the radio will start to flash
green indicating that it is receiving data. When all data has been sent from the computer, the radio will restart itself.
http://www.baofengradio.us
http://baofengradio.us
36