Baofeng UV-5RV2+ Operating Manual page 34

Duplex Channels
The following instructions assume that a duplex channel has been set up in VFO mode on the upper display and that VFO mode
is still active.
Procedure: Saving (Programming) a Duplex Channel to Memory
1. Press the [MENU] button to enter the menu.
2. Enter [2] [7] on the numeric keypad to get to MEM-CH.
3. Press the [MENU] button to select.
4. Use the [UP] and [DOWN] buttons to select a memory channel, or enter it in directly on the numeric keypad.
5. Press the [MENU] button to confirm.
6. Press the [SCAN] button to activate reverse mode. If this does not work, enter the frequency manually.
7. Enter [2] [7] on the numeric keypad to get to MEM-CH.
8. Press the [MENU] button to select.
9. Use the [UP] and [DOWN] buttons to select a memory channel, or enter it in directly on the numeric keypad.
10. Press the [MENU] button to confirm.
http://www.baofengradio.us
http://baofengradio.us
34