Uniden BCD396XT Reference Manual page 70

Set Range
This option sets the range for a POI.
In this menu, the setting unit depends on the setting in Set Unit.
When you select mile in Set Unit the displayed unit will be miles.
When you select km in Set Unit the displayed unit will be kms.
The valid setting range is from 0.05 to 4.0, by 0.05 steps.
Press [E / yes / gps] to accept the setting and return to the previous menu.
Note: This setting menu appears only in POI .
Set Heading
This option sets the heading direction-based alerts.
The options are:
All Range
North ( 0º)
NE ( 45º)
East ( 90º)
SE (135º)
Press [E / yes / gps] to accept the and return to the previous menu.
Note: This setting menu appears in Dangerous Xing and Dangerous Road .
Set Speed Limit
This option sets the speed limit for location alerts. The scanner only alerts when your speed is over this
setting.
In this menu, the setting unit depends on the setting in Set Unit.
When you select mile in Set Unit the displayed unit will be mph .
When you select km in Set Unit the displayed unit will be km/h .
The valid setting range is from 0 to 200, in steps of 1.
Press [E / yes / gps] to accept the entry and return to the previous menu.
Note: This setting menu appears in Dangerous Xing and Dangerous Road .
Friday, November 07, 2008
The scanner always sounds an alert and turns on the Alert Light when you go into
range of the location.
South (180º)
SW (225º)
West (270º)
NW (315º)
70