Uniden BCD396XT Reference Manual page 48

When you select Set Spacing , the following spacing values can be selected:
5.00 kHz
18.75 kHz
35.00 kHz
50.00 kHz
65.00 kHz
81.25 kHz
95.00 kHz
Turn the [Scroll Control] to select. Press [E / yes / gps] to set the Spacing.
Note: If Base Freqs haven t been set yet, the setting of Offset and Spacing will not be accepted.
For rebanded systems, the most likely settings for Base (Lower and Upper), Offset and Spacing in the table
are:
Band Plan Base Freq (Lower) Base Freq (Upper) Offset Polarity Spacing
1
2
Set Site Type
You can select the site type for EDACS WIDE/NARROW system.
Wide(Standard)
Narrow
Press [E / yes / gps] to accept and return to the previous menu.
Set Frequencies
You can select a stored frequency or enter a new system frequency.
Frequencies already set are displayed as a Menu Item and "New Frequency" is displayed as the last one.
For example, if you have stored "851.0125MHz" and "868.9875MHz", the selectable items are as follows:
Note: At first, only "New Frequency" is displayed.
The limit of trunk frequencies in a site is 500 - 1000. You can store up to 1000 total TGID and trunk
frequencies. When it is over the limit, the scanner sounds an Error Tone.
Friday, November 07, 2008
6.25 kHz 10.00 kHz
20.00 kHz 25.00 kHz
37.50 kHz 40.00 kHz
55.00 kHz 56.25 kHz
68.75 kHz 70.00 kHz
85.00 kHz 87.50 kHz
100.00 kHz
851.025MHz
851.0125MHz
EDACS wide site
EDACS narrow site
Sel Frequency
851. 0125MHz
868. 9875MHz
New Frequency
12.50 kHz
30.00 kHz
43.75 kHz
60.00 kHz
75.00 kHz
90.00 kHz
854.000MHz 440
868.9875MHz 0
48
15.00 kHz
31.25 kHz
45.00 kHz
62.50 kHz
80.00 kHz
93.75 kHz
+ 25 kHz
+ 25 kHz