CrimeStopper CS-882.OEM Install Manual

CS-882 OEM
ALARM UPGRADE FOR
FACTORY REMOTE KEYLESS ENTRY SYSTEM
INSTALLATION PRECAUTIONS & WARNINGS
NOTE: This system does not improve or affect the range of the factory remote keyless entry transmitters.
This is an ADD-ON system only. The arm/disarm range of this system will be identical to that of the
Factory Keyless' Lock/Unlock range.
BEFORE BEGINNING, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR
BAGS, ABS BRAKES, AND BATTERY).
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals, steering column,
or any other moving parts in the vehicle.
SUGGESTED COMPONENT MOUNTING
CONTROL MODULE: Underdash Mounting: If you are locating the control unit underdash, conceal module away
from any intruders. DO NOT Mount the control unit or wiring harness where they can become entangled with
moving parts such as brake/gas/clutch pedals, or the steering column.
LED: Mount the red LED in a visible location on the dashboard or console.
Shock Sensor: Mount the included shock sensor with wire ties to an under dash wire harness or fasten to a panel.
Disarm/Program Button: Mount the Override/Program push-button in a hidden location easily accessible to the
user in case the system must be disarmed without the use of the transmitter. This switch is also used to program
certain features.
SIREN (Not included): If you use a siren with your system, we recommend mounting it under the hood to an inner
fender-well or other body surface with the open end facing downward. Be sure the WHITE/RED wire is
programmed for siren output. See programming option #5.
TECH SUPPORT
Mon-Fri 8:00 AM-4:30 PM Pacific Time
(800) 998-6880
OPERATION
ARMING
To arm the alarm and lock the doors, press the Lock button of your Factory Keyless Remote Control. The 882
OEM system will sense the Door Lock signal and Arm. The lights will flash once, the vehicle horn or siren will chirp
once. After 3 seconds, the LED indicator will begin flashing slowly and Immobilizer circuits become active. This
system is now armed and ready to protect the vehicle.
ALARM TRIGGERING:
If there is an intrusion into the vehicle or hard impact to the body the alarm will sound which consists of flashing
lights and siren or pulsing car horn for 30 seconds. After the 30 second alarm cycle duration the system will stop,
but is still armed. LED will begin flashing rapidly indicating the alarm has been triggered.
DISARMING:
To disarm the CS-882 OEM, press the Unlock button of your Factory Keyless Remote. The CS-882 OEM system
will sense the Door Unlock signal and Disarm. The lights will flash twice and the vehicle horn or siren will chirp
twice. The LED will stop flashing. If the system was tripped in your absence, then the siren or horn will chirp 4
times and the lights will flash 4 times. If your hear 4 chirps/flashes, we recommend inspecting your vehicle for a
theft attempt or damage.