Uploading A Vt Pro-E Project - Crestron Isys TPS-5000L Operation Manual

12 Inch Lectern/Wall Mounted Touchpanel
The TPS-5000L touchpanel
source file has the extension
.vtp. A compiled VT Pro-e file
has the extension .vtz.
40 • 12 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-5000L

Uploading a VT Pro-e Project

The VT Pro-e file can be uploaded to the touchpanel using VT Pro-e or via the
Crestron Viewport.
Upload via VT Pro-e
1. Start VT Pro-e.
2. Select File | Open | Project to view the "Open" window, navigate to the VT
Pro-e file (.vtz), and click Open.
3. Select File | Upload Project.
Upload via Crestron Viewport
1. Verify that the procedure for "Communication Settings" that begins on page
36 has been performed.
2. As shown after this step, select File Transfer | Send Touchpanel
(alternatively, press Alt+T) from the Viewport menu.
File Transfer | Send Touchpanel Command
3. As shown after this step, select the NET ID of the TPS-5000L touchpanel
and then click OK. The "Touch Panel Transfer" window appears (refer to
the subsequent graphic).
"Select Network ID" Window
NOTE: When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed when transferring
through a control system.
Crestron Isys™ TPS-5000L
Check Send Direct to Wired Touchpanel if
connected via RS-232 directly to touchpanel.
Operations Guide - DOC. 5783A