Crestron SIMPL™ Windows
Installation & Operations Guide – DOC. 5728C
In X Series processors, the contents of the mailbox is deleted whenever a new
program is uploaded to the control system, or a new file is saved to the mailbox.
In 2 Series processors, the contents of the mailbox is deleted only when a new file is
saved to the mailbox; uploading a new program will not erase the file.
Identify Transmitter ID
The Identify Transmitter ID command verifies communication between an IR
(infrared) or RF (radio frequency) transmitter and a receiver, such as the CNIRGW
or CNRFGWA.
The control system program must contain a gateway at the ID where the physical
gateway is located.
Simply point the transmitter at the receiver and press any button; if valid
communication exists, the Transmitter ID of the unit will be displayed, and the
Button ID field will show the ID of the button that was pressed.
Switch Processors (CNRACKX-DP)
The Switch Processors command is used with the CNRACKX-DP (dual processor)
to switch communication from one processor to the other.
Software
Crestron SIMPL Windows • 109