Software
VT Pro-e Programming
The Serial Mouse Control Driver and PC configuration must be programmed in VT Pro-e and
the project uploaded to the touchpanel. This entails the following steps, which are explained
in detail in this section.
An RGB object must be created on a page or subpage. To create an RGB object, perform the
following steps.
Project Window Active
Select Project Properties
16 • Serial Mouse Control Driver
1. In VT Pro-e, open the touchpanel project.
2. As shown below, make sure that the project window is the active window.
3. As shown below, select Edit | Project Properties.
4. In the Project Properties dialog box, select the Pad Area tab.
Crestron Serial Mouse Control Driver
Programmer's Guide - DOC. 5916A