Pc To Touchpanel Ethernet Communication - Crestron Touch the PC v1 Programmer's Manual

Crestron Serial Mouse Control Driver
Cresnet Communication #3 - Lectern Touchpanel with TPS-XVGAL
VGA
PORT
PC
CRESNET COMMUNICATION #3 - LECTERN TOUCHPANEL WITH TPS-XVGAL CARD
REF
1
A
2
B
3
C
Control System
1
A standard stranded VGA monitor cable with DB15F to BNC-5 adapter is required. Both are commercially available.
2
Standard null modem serial cable.
3
For Cresnet 4-wire specifications, refer to Appendix 3 on page 25 of this guide.

PC to Touchpanel Ethernet Communication

For Serial Mouse Control Driver operation using Ethernet communication from the PC to the
touchpanel, refer to the following two sections, Cabling Connections and Ethernet Setup.
NOTE: To connect the LAN port on the control system and the LAN port on the touchpanel
base directly instead of through an Ethernet hub, use an Ethernet crossover cable (not
supplied).
NOTE: A Crestron TPS-ENET or TPS-ENETL Ethernet expansion card must be installed in
the touchpanel to enable Ethernet communication. For further information, refer to the TPS-
ENET or TPS-ENETL Operations & Installation Guide (DOC. 5867 or 5829, respectively).
The latest revisions can be obtained from the Products page (PRODUCT MANUALS
section) or Downloads page (MANUAL Library) of Crestron's website (www.crestron.com).
New users are required to register to obtain access to the FTP site.
NOTE: The Crestron control system must contain an Ethernet expansion card to enable
Ethernet communication. On CNX Generation control systems, the port may be labeled LAN
or LAN/DPA. On 2-Series control systems, the port may be labeled LAN A or LAN B. For
further information about CNX Generation Ethernet cards, refer to the CNXENET or
CNXENET+ Operations & Installation Guide (DOC. 8129 or 8153, respectively). For further
information about 2-Series Ethernet cards, refer to the C2ENET Operations & Installation
Guide (DOC. 5962). The latest revisions can be obtained from the Products page (PRODUCT
MANUALS section) or Downloads page (MANUAL Library) of Crestron's website
(www.crestron.com).
Programmer's Guide - DOC. 5916A
A
RGB CABLE
COMM. CABLE
B
COM
PORT
CREST RON
FROM
DEVICE
PORT CONNECTOR
VGA DB-15, male
PC
COM DB-9, female
PC
NET 4-wire Cresnet
2. Proceed to "SIMPL Windows
CONTROL
COM
SYSTEM
PORT
P R OFE SS I ON AL C ONTROL PROC ESSOR MENU
BKLT
PRO 2
NET (OR
CRESNET)
PORT
CRESNET
WIRING
C
CABLING REQUIRED
to CONNECTOR
BNC-5, male
DB-9, female
4-wire Cresnet
Programming" that begins on page 13.
Software
LECTERN TOUCHPANEL
(OR TPS-TPI) WITH
TPS-XVGAL
RGB
INPUT
PORT
NET
PORT
TO
DEVICE PORT
Touchpanel RGB
Control System COM
Touchpanel NET
Serial Mouse Control Driver • 9