Shure AXT610 Manual

AXT610 -- ShowLink Access Point
AXT610 ShowLink Access Point
The AXT610 ShowLink™ access point enables real-time remote control of the Axient™ transmitters. The access
point allows comprehensive management of transmitter parameters from the receiver or Wireless Workbench 6
using 2.4 GHz wireless network communication. All parameter changes occur without interruption to the performer.
Multiple access points can extend the operational range or increase the number of transmitters supported on the
ShowLink network.
Features
• Real-time wireless remote control of up to 16 transmitters per ShowLink access point
• Automated channel selection - Independently scans 2.4 GHz frequency range and determines best channel for
use
• Receives power via Power over Ethernet (PoE) network connection or from an external power supply
• Easy transmitter authentication - Recognizes linked transmitters upon IR sync
• Provides coverage area approximately the same as the transmitter's UHF range (depending on the RF squelch
setting of the receiver)
• Automatic hand-offs between multiple access points extend coverage range
• Automatic frequency agility - Moves a ShowLink network to the best available 2.4 GHz channel in the event of
signal degradation
• Versatile mounting options - Fits readily available microphone stand adapters and features built-in threading for
permanent installation
• Wireless Workbench 6 system supports networked control of all device functions and provides a ShowLink plot
for viewing 2.4 GHz signal levels
ShowLink Access Point Overview
① ShowLink 2.4 GHz detachable antenna
For 2.4 GHz signals
② ShowLink Data Status LED (blue)
• ON Steady: Linked, no data transmission
®
1/12