Remove The Shipping Materials; Clean The Appliance - Majestic MARQUIS Series Installation And Appliance Setup

5. Ensure all three bottom glass latch tabs are engaged
and centered in the three slots in the glass frame. The
glass latch tab should protrude through the slot in the
glass frame about 1/4 in. See Figure 11.5
Figure 11.5 Bottom Glass Latch Tabs Installed in Glass Frame
6. Engage the three glass latches on top. Push the top
of the glass toward the fireplace. Use index fingers
to manipulate top glass latches and pull out and latch
the three glass assembly latches into the engagement
grooves. See Figure 11.6 and Figure 11.7.
Figure 11.6 Top Glass Latch Access
Figure 11.7. Top Glass Latch Detail
GLASS FRAME
TAB
REFRACTORY
TAB
Majestic • MARQ42STIN Installation Manual • 2272-980 Rev. H • 4/21
Removing Fixed Glass Assembly
• Remove glass assembly by reversing these glass in-
stallation instructions.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath
the firebox.
• The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before finishing work on the whole hearth is
complete. Splatter guards may be factory installed
or accompany the decorative barrier front of the ap-
pliance, depending on the fireplace model. Splatter
guards must be removed before appliance is fired.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
41