Brother DCP-J552DW Service Manual page 51

Code 1 Code 2
B0 01
B0 02
B0 03
B0 04
BF 01
BF 02
C0 01
C0 02
C0 03
C0 04
C0 10
C0 11
C0 20
C0 21
C0 22
C0 30
C0 31
E0 01
E0 02
E0 03
*1
Fax communication establishment: Fax communication is established when DIS (presentation
signal of receiving conditions) is received from the calling station, and when NSS or DCS
(communication test signal) is received from the calling station.
Detect polarity reversion.
Unable to receive the next-page data.
Unable to receive polling even during turn-around transmission
due to call reservation.
A PC interface error occurred.
The [Stop] key was pressed and communication was cancelled
before fax communication could be established
The [Stop] key was pressed and communication was cancelled
after fax communication was established
There is no common modulation mode or the polling has failed.
JM cannot perform detection.
CM cannot perform detection.
Unable to perform CJ detection.
V.34 negotiation or training does not end.
A modem error was detected during V.34 negotiation or
training.
A modem error was detected during sending of commands.
A modem error was detected during receiving of commands.
The control channel connection timed out.
A modem error was detected during sending of image signals.
A modem error was detected during receiving of image signals.
1300 Hz signal detection failed the counter-communication
inspection.
PB signal detection failed the counter-communication
inspection.
A command was not detected from RS232C through counter-
communication.
2-18
Cause
*1
.
*1
.
Reference
Page
Section
4.9.3 "A
communicat
ions error
occurs"
Confidential