Brother DCP-J552DW Service Manual page 189

Note • Do not remove the protective part. Doing so in this state will make the ink inside the ink
tubes flow out.
The ink absorber felt (for the ink refill ASSY) attached to the bottom of the ink refill
•
ASSY may get stained with ink. If there is a significant stain, replace the ink absorber felt.
Assembling Note
• When attaching the tube clamps to the ink supply tubes, view the machine from the front, attach
the right tube clamp (1) to magenta, bind cyan and yellow, attach the left tube clamp (2) to black,
and bind yellow and cyan (refer to the illustration on the previous page).
Attach the tube clamp by aligning it to the dented part of the tube support plate shown in the
•
illustration in the previous page.
After installing the ink refill ASSY, route the ink supply tubes to the tube guide based on the color
•
order described in the previous page without overlapping. Next, set it into the sponge and route it
to the tube support wire elbow.
• Attach the head joint to the head/carriage unit using the joint spring as shown below. Make sure
that all of the four ink supply tubes are routed in front of the guide boss.
Head joint spring
Head joint
Ink supply tubes
Head joint
rubber
Upper cover
Guide boss
Carriage flat cable
3-72
Head/carriage unit
PF encoder disk
Head joint spring
Head joint
Head/carriage unit
(3_097)
Confidential