Cable Routing For Line Connection Modules - Siemens SINAMICS S120 Device Manual

Electrical installation
4.5 Connections
Safety and EMC
Risk of death due to hazardous voltage when covers are missing
If covers are missing, live parts may be touched, which may result in death or serious
injury.
• Re-install all covers that you have removed for feeding in cables before putting the
Note
Internal cabinet wiring
It must be ensured when laying cables that existing wiring inside the cabinet is not changed.
Note
EMC-compliant shielding
In order to achieve EMC-compliant shielding, the shield plates must be reattached before
putting the cabinet into operation.
The shields of the motor cables must be attached to the EMC shield bar (option M70), and
the PE cables to the PE bar.
4.5.12.2

Cable routing for Line Connection Modules

For the Line Connection Modules, the customer must carry out the following cabling or
connection work:
Table 4- 14
Cable routing
Cable for the line supply (L1, L2, L3, PE)
Signal cables
Note:
The "Basic rules for cable routing" and "Preparatory steps" described above must
be observed whenever any cabling or connection work is performed.
104
WARNING
Cabinet Module into operation.
Checklist for cabling or connection work for Line Connection Modules
Completed?
Cabinet Modules NEMA
Manual, 04/2014, A5E03586450A