Thermostat Installer Options - Aprilaire 8710 Safety & Installation Instructions

7

THERMOSTAT INSTALLER OPTIONS

The thermostat and control module are factory set to
Zone = 01 and Home = 01
communication (an equipment call), the thermostat will
display LINKED on the screen.
If only one wireless thermostat/control module set is
used in an application and there are no other units
installed within 500 feet, the thermostat and control
module can be left with the factory default setting of
Zone = 01 and Home = 01
Installer options can be accessed by pressing and
holding the ENTER key for seven seconds. The LCD
displays Option 01. Skip Options 1, 2 and 3 by pressing
the NEXT key until Option 04 is displayed. (See Installer
Options Chart on page 9 or Option 04 on page 12).
Press CANCEL anytime to exit installer options.
APPLICATIONS USING MULTIPLE THERMOSTAT
AND CONTROL MODULE SETS
If multiple wireless thermostat/control module sets are
used that are less than 500 feet away from one another,
the zone and/or home number for each thermostat must
be changed and each thermostat needs to be
control module. It's helpful to have the thermostat and
control module near each other while setting the Zone
and Home numbers and linking.
and are linked. After the first
.
Linked
Anytime the Zone and/or the Home number is changed
in the thermostat,
that the thermostat needs to be linked with a control
module. The thermostat displays
successfully linked with a control module.
START THE LINKING PROCESS
Make sure the thermostat and control module are powered and the module LED is
blinking green.
Press and hold the
module. The LED turns yellow. Continue holding until the
LED blinks red/yellow, then release. The module will
continue blinking red/yellow for about six minutes until
the module is linked to a thermostat or power is
removed.
Go to Option 01, page 10.
For troubleshooting, see page 18.
RESETTING FACTORY DEFAULTS
To reset the factory defaults, remove the batteries and
re-install them while holding the
changes will default to the factory settings. This will
require setting the Zone and Home number and linking
to a
to a control module, resetting the time of day and
programming schedules if necessary. Refer to the
Installer Options Chart default settings to make any
additional changes.
LINK blinks on the display indicating
LINKED
PUSHBUTTON on the control
SYSTEM
when
key. All prior
8