Setup And Testing                            17; Installer Setup Wizard And Installer Setting                             17 - Aprilaire S86N MU Manual

FIGURE 10 - INDOOR AIR QUALITY EQUIPMENT WIRING DIAGRAMS (S86N MUPR ONLY)
DUCT MOUNTED EVAPORATIVE HUMIDIFIERS
(APRILAIRE SERIES 400, 500, 600, 700)
TRANSFORMER
I2
HUMIDIFIER
I1
SOLENOID
90-2570
STANDALONE OR RESIDENTIAL STEAM HUMIDIFIER
(APRILAIRE SERIES 300, 800)
HUMIDIFIER
I2
DRY CONTACT INPUT
I1
90-2680
NOTE: The I1/I2 output is a dry contact closure The HUMIDIFIER wiring diagram assumes the
control is powering a solenoid valve The DEHUMIDIFIER wiring diagram is for a normally open
dry contact input The VENTILATION wiring diagram assumes the control is for a normally closed
damper. Refer to the individual humidifier, dehumidifier or ventilation installation instructions for
product specific wiring details.
16
DEHUMIDIFIER
(APRILAIRE SERIES 1800, e-SERIES)
DEHUMIDIFIER
I2
DRY CONTACT INPUT
I1
90-2569
VENTILATION
(APRILAIRE SERIES 8100)
TRANSFORMER*
I2
DAMPER
I1
90-2571
*If required by ventilation accessory.
SETUP AND TESTING
INSTALLER SETUP WIZARD AND
INSTALLER SETTING
The first time the thermostat is powered
up (or after a factory reset) it will enter the
Installer Setup Wizard All Installer Settings
can be set through this process The
Installer Settings are also accessible in the
Installer Menu
HOW TO ENTER THE INSTALLER MENU:
1. Press Select to enter the Main Menu
2. Use or to navigate to Settings,
press SELECT
3. Press and hold
and for 3 seconds
to unlock the Installer option
4. Use or to navigate to Installer,
press SELECT Refer to the chart at right for
options
INSTALLER
MENU OPTIONS DESCRIPTION
Essential HVAC
HVAC Settings
equipment (equipment
type, stages, etc)
Advanced HVAC control
HVAC Advanced (effsets, deadbands,
staging, protection, etc)
IAQ Settings Humidifier, Dehumidifier,
(S86N MUPR Air Cleaner, and
only)
Ventilation configuration
Installer test for
Test configured equipment
relay outputs
Reset all settings to
Reset
factory default
17