Step; Date & Time Adj; Tot; Vfo Mode - Yaesu FT5Dr Advance Manual

18 STEP

Sets the frequency step when the dial knob is turned.
1. Press and hold the [F
For details, refer to "Changing the Frequency Step" in the Operating Manual.
19 DATE & TIME ADJ
Set the date and time function of the built-in clock of the FT5DR/DE.
In the factory settings, the date and time are automatically set when positioning the GPS
signal, so in this case no manual setting is necessary.
1. Press and hold the [F
2. Rotate the DIAL knob to select the year, month, day, hour and minute.
3. To activate the time signal (alarm goes off every hour on the hour), touch [SIGNAL].
The check box will be checked.
4. Touch [OK].

20 TOT

Set the transceiver to automatically return to receive mode after transmitting continuously
for a certain period of time. The TOT function limits inadvertent transmission of unneces-
sary signals, and unwanted battery power consumption (time-out timer function).
1. Press and hold the [F
2. Rotate the DIAL knob to set the time for the transceiver to automatically return to
receive mode state in steps of 30 seconds.
OFF/30 sec to 10 min 00 sec
3. Selecting OFF disables the TOT function.
Remark The default setting: 3 min 00 sec
• When the time-out timer function is active, a beep is emitted when a continuous
transmission nears the set time. About 10 seconds later, the transceiver returns to the
receive mode.
• The TOT setting is retained until "OFF" is selected in step 3 above.

21 VFO MODE

Sets the frequency tuning range while operating in VFO mode.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired tuning range.
ALL Tuning continues to the next band when reaching the end of a band.
BAND Tuning continues to the other end of the current band when reaching
the end of the band.
Remark The default setting: ALL
] key  touch [CONFIG]  [18 STEP]
MENU
] key  touch [CONFIG]  [19 DATE & TIME ADJ]
MENU
] key  touch [CONFIG]  [20 TOT]
MENU
] key  touch [CONFIG]  [21 VFO MODE]
MENU
63