Memory Skip; Memory Write; Signaling Menu; Bell - Yaesu FT5Dr Advance Manual

5 MEMORY SKIP

You can set the scan method for scanning memory channels.
1. Press and hold the [F
For details, see "Setting Skip Memory Channel and Specified Memory Channel"
(page 21).

6 MEMORY WRITE

Set whether to register to the lowest unused memory channel number following the channel
number you most recently used, or to the lowest unused memory channel number.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
NEXT Registers to the smallest unused memory channel number which
comes after the channel number you used most recently.
LOWER Registers to the unused memory channel having the lowest memory
number.
Remark The default setting: NEXT

SIGNALING Menu

1 BELL

Set whether or not to alert you of a call from a remote station using the bell.
1. Press and hold the [F
For details, see "Notification of a Call from a Other Station by the Bell Function"
(page 14).

2 DCS CODE

Select the DCS code out of the 104 codes from 023 to 754.
1. Press and hold the [F
For details, see "Setting the DCS CODE" (page 11).

3 DCS INVERSION

The transmit and receive DCS code phase may be inverted when using the digital code
squelch function.
1. Press and hold the [F
2. Rotate the DIAL knob to select the phase combination for transmit/receive.
RX Homeomorphic / Both Phase / Inverted Phase
TX Homeomorphic / Inverted Phase
Remark The default setting: Receive [Homeomorphic], Transmit [Homeomorphic]

4 DTMF MODE

Set the transmission method of the registered DTMF code.
1. Press and hold the [F
For details, see "Transmitting the Registered DTMF Code" (page 33).
] key  touch [MEMORY]  [5 MEMORY SKIP]
MENU
] key  touch [MEMORY]  [6 MEMORY WRITE]
MENU
] key  touch [SIGNALING]  [1 BELL]
MENU
] key  touch [SIGNALING]  [2 DCS CODE]
MENU
] key  touch [SIGNALING]  [3 DCS INVERSION]
MENU
] key  touch [SIGNALING]  [4 DTMF MODE]
MENU
52