Installing The Wwan I/O Board - Dell Latitude 3520 Service Manual
Hide thumbs
Also See for Latitude 3520:
- Owner's manual (104 pages) ,
- Setup and specifications (24 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
About this task
The following image indicates the location of the WWAN I/O board and provides a visual representation of the removal
procedure.
NOTE:
The following steps are applicable only for 4G LTE enabled systems.
Steps
1. Remove the two (M2x3) screws that secure the WWAN I/O board to the palmrest assembly.
2. Open the latch and disconnect the WWAN cable from the connector on the WWAN I/O board.
3. Lift and remove the WWAN I/O board from the palmrest assembly.
Installing the WWAN I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WWAN I/O board and provides a visual representation of the installation
procedure.
NOTE:
The following steps are applicable only for 4G LTE enabled systems.
84
Removing and installing components
- Quick Links:
- Removing the Base Cover
Hide quick links:
Advertisement
Table of Contents
