6. Connect the battery cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Install the
SIM card tray
3. Install the microSD-card.
4. Follow the procedure in
I/O cable
Removing the I/O cable
Prerequisites
1. Follow the procedure in
2. Remove the
SIM card tray
3. Enter the
service
mode.
4. Remove the
base
cover.
About this task
The following image indicates the location of the I/O cable and provides a visual representation of the removal procedure.
Steps
1. Peel the adhesive tape, open the latch and disconnect the I/O cable from the connector on the system board.
2. Peel the adhesive tape and unroute the I/O cable from the routing guides in the palmrest assembly.
3. Peel the adhesive tape, open the latch and disconnect the I/O cable from the connector on the I/O board.
4. Lift and remove the I/O cable from the palmrest assembly.
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
computer.
computer.
Removing and installing components
47