Steps
1. Align and place the solid-state drive conversion plate on the system board.
2. Install the two (M2x3) screws to secure the solid-state drive conversion plate to the system board.
Next steps
1. Install the
M.2
SSD.
2. Install the
base
cover.
3. Exit the
service mode
4. Install the
SIM card tray
5. Install the microSD-card.
6. Follow the procedure in
Hard-disk drive assembly
Removing the hard-disk drive assembly
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Remove the
SIM card tray
4. Enter the
service
mode.
5. Remove the
base
cover.
About this task
The following image indicates the location of the hard-disk drive assembly and provides a visual representation of the removal
procedure.
NOTE:
The following steps are applicable only for systems shipped with 3-cell battery.
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
computer.
computer.
Removing and installing components
31