Table of Contents
Advertisement
Printing: Quick Start
The primary function of the Wraptor A6200 Wrap Printer Applicator is to print labels for wire
identification and wrap them on the wire or cable. However, you can also print a label without wrapping
it.
When you print labels to the Wraptor A6200 printer from your labeling software, the printer does not
immediately print the labels. The software sends the labels to the printer's internal memory. Because
the printer requires an operator to insert a wire or cable for wrapping, or to remove a printed label, the
operator must initiate printing at the printer.
Printing and Wrapping
The process flow is as follows:
On your computer:
1. Design labels on your computer using Brady Workstation software.
2. Send your completed labels to the printer with the Print command.
On the printer:
1. On the home screen, tap Print Jobs.
2. Tap the check box for a job to select it and then tap Add.
This places the job into the print queue and displays the Printing (Run) screen.
For details about the Run, Print Jobs, and Print Queue functions on the home screen, and
related settings, see "Running Jobs" on page 33, "Managing Print Jobs" on page 29, and
"Managing the Print Queue" on page 32.
3. Physically insert a cable or wire into the printer jaws. Push the wire against the trigger bars
until the jaws clamp. The trigger bars must be pressed in fully to initiate printing and wrapping,
or just wrapping. Hold the wire loosely during wrapping so that the wrapper mechanism can
move freely.
Wraptor A6200 User Manual
WARNING!
The wrapper mechanism contains hazardous moving parts. Keep
fingers and other body parts away.
General Operation
Printing: Quick Start
27
Advertisement
Table of Contents
