Hot-Swap Rear Drive Assembly Replacement; Remove The Hot-Swap Rear Drive Assembly - Lenovo HR630X V2 User Manual

Hot-swap rear drive assembly replacement

Use this information to remove and install the hot-swap rear drive assembly.
Note: The term "hot-swap drive" refers to all the supported types of 2.5-inch hot-swap hard disk drives and
hot-swap solid-state drives.

Remove the hot-swap rear drive assembly

Use this information to remove the hot-swap rear drive assembly.
About this task
The following illustrates how to remove the 2.5-inch rear drive assembly.
Attention:
• Read "Installation Guidelines" on page 27 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Remove the top cover. See "Remove the top cover" on page 106.
Step 2. Remove the drives or drive fillers installed in the hot-swap rear drive cage. See "Remove a hot-
swap drive" on page 37.
Step 3. Disconnect the hot-swap rear drive cage cables from the system board or the PCIe adapter.
Step 4. Hold the two blue touch points and directly lift the hot-swap rear drive cage out of the chassis.
Figure 23. Hot-swap rear drive cage removal
48
HR630X V2 User Guide