Step 1.
Touch the static-protective package that contains the new part to any unpainted surface on the
outside of the server. Then, take the new part out of the package and place it on a static-protective
surface.
Step 2.
Install the front I/O module.
Figure 40. Installing the front I/O module
a.
Insert the front I/O module into the front chassis.
b.
Install the screw to secure the front I/O module in place.
After you finish
1. Connect the cables of the front I/O module to the processor board. See
routing" on page
153.
2. Complete the parts replacement. See
Hot-swap drive replacement
Follow instructions in this section to remove and install a hot-swap drive. You can remove or install a hot-
swap drive without turning off the server, which helps you avoid significant interruption to the operation of
the system.
•
"Remove a hot-swap drive" on page 73
•
"Install a hot-swap drive" on page 74
Notes:
• The term "hot-swap drive" refers to all the supported types of hot-swap hard disk drives, hot-swap solid-
state drives, and hot-swap NVMe drives.
• Use any documentation that comes with the drive and follow those instructions in addition to the
instructions in this topic. Ensure that you have all the cables and other equipment that are specified in the
documentation that comes with the drive.
• The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all drive
bays covered or occupied. The vacant bays are either covered by an EMI-protective panel or occupied by
ThinkSystem SR655 V3 User Guide
72
"Complete the parts replacement" on page
Chapter 6 "Internal cable
151.